
WA_DEV_FEX20_PTS_004 Rev 001 June 30, 2010 23
Expansion Card Product Technical
Specification
Table 10: Reset State Definition
Set to supply 1V8 or 2V8 depending on I/O type
Internal pull-down with ~60K resistor.
Internal pull-up with ~60K resistor to supply 1V8 or 2V8 depending on I/O type.
Caution: Undefined must not be used in an application if a special state is required at reset.
These pins may be a toggling a signal(s) during reset.
4.3. General Purpose Input/Output
The Expansion Card provides a total of 20 General Purpose I/O. These can be used to control any
external device such as GPS, Bluetooth, LCD or any other external application.
Note that these GPIOs are only available if the multiplexed counterparts aren’t used.
Refer to the table below for the pin description of the GPIO.
Table 11: GPIO Pin Description
* If a Bluetooth module is used, these GPIOs must be reserved.
Refer to section 4.2 Electrical Information for Digital I/O for open drain, 2V8 and 1V8 voltage
characteristics and reset state definitions.
Kommentare zu diesen Handbüchern