Sierra Wireless USB 598 Betriebsanweisung PDF herunterladen (Seite 17)

Installing the Software

Section 2A. Installing the Software 9

10. If a message that you must restart your computer is displayed, click Yes to restart your

computer. Wait until your computer restarts.

11 . Proceed to “Starting the Windows Software” on page 11.

Installing the Software on a Mac Computer

System Requirements

The Sprint Mobile Broadband USB modem is supported on a MacBook™, MacBook Air™,

MacBook Pro, PowerBook

G4, Power Mac

G5, or desktop iMac computer running Mac

OS X version 10.4 or newer.

To check your version, from the Apple menu ( ) choose

About This Mac. If your version is

earlier than 10.4, then you must upgrade to version 10.4 or newer; contact an Apple

reseller, an Apple retail store, or visit

www.apple.com/store.

To install and run the USB modem and accompanying Sprint SmartView software on a

Mac computer, you will need one USB slot.

Installing the Software and Drivers

1. If your USB modem has not yet been activated, ensure you are in the network

coverage area (not roaming).

2. Remove the protective cap from the USB modem by placing your fingers on the sides

of the cap and carefully pulling it off.

Note

Do not insert the USB modem or the USB extension cable into a USB hub or, if your keyboard is

separate from your laptop, a USB slot on your keyboard.

Note

As part of the installation process you will be prompted to restart your computer; save any

open documents.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Keine Kommentare

Sierra Wireless USB 598 Betriebsanweisung Seite 17