Sierra Wireless UMTS Spezifikationen Seite 59
- Seite / 296
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Modem Status, Customization, and Reset Commands
Rev. 8 May.12 Proprietary and Confidential 59
!NASREL
Supporting chipsets:
• All
Note: Only the execution
operation (“=”) is password-
protected.
Set/report supported NAS release compliance version
Configure the modem to support a specific NAS (Non-Access Stratum) release
compliance version.
Usage:
• Execution: AT!NASREL=<nasrel>
Response:
OK
Purpose: Set the desired version (<nasrel>).
• Query: AT!NASREL?
Response:
!NASREL:
NAS Release: Release 5
(or Release 99)
OK
Purpose: Report the NAS release compliance version currently being used.
• Query List: AT!NASREL=?
Purpose: Return the command format (for !NASREL = ) and the supported
parameter values.
Parameters:
<nasrel> (NAS release compliance version)
• 00 = Release 99 (Default)
• 01 = Release 5
Note: If you use
!REL
, use the default value (1) for that command’s <sgsnr> and
<mscr> parameters. You must choose the appropriate compliance version using
!NASREL
.
Table 3-2: Modem status, customization, and reset commands (Continued)
Command Description
- AirPrime MC/SL-Series 1
- (UMTS/LTE) 1
- Extended AT Command 1
- Reference 1
- Trademarks AirCard 4
- Contact 4
- Information 4
- Revision 5
- Contents 11
- 1: About This Guide 13
- Command access 14
- Command timing 14
- Result codes 15
- References 15
- Terminology and acronyms 15
- Current firmware versions 15
- Document structure 16
- About This Guide 17
- Table 1-9: GPS commands 22
- Conventions 25
- 2: AT Password Commands 27
- Return modem hardware ID 36
- Return modem hardware version 37
- Generate melody on buzzer pin 39
- Enable/disable DARP for SAIC 47
- Configure DIO channels 49
- Enable/disable GCF test mode 53
- Set/return current SIM type 53
- Set/return HSDPA category 54
- Set/report HSUPA category 54
- Configure LTE NAS settings 56
- Configure MT PDP port mapping 57
- (or Release 99) 59
- Return Network Subset codes 62
- Return package version string 66
- Ping an IP address 71
- Select RAT acquisition order 75
- Read modem’s SKU 77
- Set/report Sleep Enable state 78
- Return wake-up event type 80
- 4: Diagnostic Commands 85
- Set/report TE-DCE baud rate 89
- 5: Test Commands 93
- Test Commands 95
- Return MT RSSI and RSQ 97
- !DAFTMACT 98
- • 0=R0 (highest gain) 99
- !DAGGAVGRSSI 99
- Return raw RSSI value 100
- Return synthesizer lock state 101
- !DASBAND 103
- !DASCHAN 103
- !DAGSTXBURST 103
- Set GSM Tx frame structure 104
- • 0=R0 (Highest gain) 105
- !DALSRXBW 105
- !DALGAVGAGC 105
- !DALGRXAGC 106
- (continued) 108
- Place modem offline 109
- Set frequency band 110
- Set modem channel (frequency) 111
- Set LNA gain state 112
- Set PDM value 113
- Turn Tx PA off 113
- Turn Tx PA on 114
- !DAWGRXAGC 115
- Set PA range state machine 118
- Enable/disable IMS test mode 120
- Key off the transmitter 120
- Key on the transmitter 121
- Turn second receiver on/off 122
- Read second receiver Rx AGC 123
- Read first receiver Rx AGC 123
- Turn transmitter on/off 123
- Set desired Tx AGC 124
- 6: Memory Management Commands 125
- Command reference 126
- 7: Voice Commands 127
- Audio profiles 128
- Profile activation 130
- Command summary 131
- Set/report CODEC Tx gain 135
- Set/report the DTMF Tx gain 137
- Set/report microphone gain 143
- Play DTMF tone 152
- Set Tx AGC 154
- Set/report Tx PCM filter tap 155
- Set Tx volume 158
- Voice Commands 159
- !AVTONEPLAY command 159
- 8: I2S Audio Commands 163
- Read a codec register 166
- Select codec mode 168
- Set codec register bit width 169
- Set/report voice decoder gain 169
- Set/report Rx voice volume 172
- Set I2S sample rate 175
- Select codec controller 178
- 9: GPS Commands 179
- Clear all GPS assistance data 184
- End an active session 184
- Initiate GPS position fix 185
- Set GPS LBS APNs 187
- Set GPS LBS APNs (continued) 188
- Set/report NMEA sentence type 192
- Request satellite information 196
- Set/report SUPL server URL 198
- !GPSTRACK 200
- Set GPS XTRA APNs 202
- Set GPS XTRA APNs (continued) 203
- Set/report GPS XTRA settings 203
- Error codes 208
- GPS Commands 209
- 10: STK Commands 211
- Display STK version 222
- 11: PAD Commands 243
- Disconnect PAD connection 246
- Disable PAD server 246
- Switch active PAD session 250
- 12: OMA-DM Commands 251
- Enter DM account credentials 255
- Configure DM sessions 258
- Commands 259
- Execution (GSM): 261
- Response: 261
- Set/report SAR backoff state 262
- (or Disable) 265
- A: Module Customization 269
- Table B-1: GSM/EDGE channels 275
- Table B-2: WCDMA Channels 276
- C: HSDPA/ HSUPA Categories 277
- D: Band Definitions 279
- Table 4-2: 3GPP bands 280
- E: ASCII Table 281
- Index (AT commands) 283
- Index — AT Commands 285
Verwandte Produkte und Handbücher für Vernetzung Sierra Wireless UMTS
(67 Seiten)
(24 Seiten)© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.655 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern