Rev 1 Dec.10 Proprietary and Confidential - Specifications subject to change 73
5.7 Flash LED (LED_FLASH)
This digital output may be used to drive a general purpose LED.
5.7.1 Pin descriptions
Tabl e 5- 1 5 describes the LED signal pin.
See Digital I/O electrical information on page 39 for 1V8 voltage characteristics
and reset state definitions.
5.7.2 Electrical characteristics
Tabl e 5- 1 6 describes the LED_FLASH signal’s electrical characteristics.
Refer to Ta bl e 4 - 2 on page 34 for basic characteristics (type, voltage).
Table 5-14: LED signal features
Feature Details
Purpose Flash LED output
• Used by host to control LED status by controlling LED diode
bias.
Implementation • Digital output. 1.8 V logic
• Source/sink maximum—8 mA
• LED behavior can be configured by adjusting software settings.
• LED pattern can be used to indicate network connection status.
• Blink rate up to 10 Hz supported
Table 5-15: LED_FLASH pin description
Pin Signal I/O I/O type Reset state Description
60 LED_FLASH O Digital output 1 and
Undefined
LED driving
Table 5-16: LED_FLASH signal electrical characteristics
Parameter Condition Minimum Typical Maximum Unit
V
OL
0.4 V
V
OH
V
I
OUT
8 mA
Kommentare zu diesen Handbüchern